The process of applying the prepared solution itself is no different from the process of plaster with ordinary solutions. Although there are some features when applying a solution of warm plaster on the prepared surface. The only difference between plaster with conventional solutions and warm plaster is that the plaster solution of warm plaster is not thrown onto the wall, but is smeared. When applying a solution of warm plaster, it is impossible to allow too fast drying of the plaster layer applied to the surface of the walls.
Want to know how much autonomous gasification is now now? You can visit our site and we find out the information you are interested in.
In order to prevent too fast drying of plaster solution, plastering is carried out in several stages. The plaster solution of warm plaster is applied with several thin layers until the completeness of the thickness of the plaster layer. The first layer is applied to the measured area of the wall with a thickness of 10-15 mm. The first layer of the applied solution is aligned and time is given for partial drying. The second layer of plaster solution is applied along the first layer to the completeness of the plaster layer of at least 30mm. The duration of drying between the layers should not exceed 3-4 hours.
The plaster solution applied to the wall surface indicated by the guide rails is leveled to a normal state. Apply a plaster solution on a moisturized wall. In order to avoid the sliding of the plaster solution, you cannot apply warm plaster with a full thick layer. Each layer of plaster is applied after a partial drying of the first layer.