Periodically, there is a need to install additional equipment in the bathroom or a variety of shelves and mirrors. In this case, the fastener element will need to be installed in a place previously lined with ceramic tiles. To install the dowel, you need to make a hole directly in the tile and in the wall.
Drilling ceramic tiles involves the use of a marker for marking, a painting tape that prevents the drill slide on the surface, a drill with two drill. One drill is necessary for drilling the tile itself, usually has a spearhead, the second is intended for drilling the wall and is selected respectively for wood, brick, concrete, etc. D. By the way, at leisure it will not be superfluous to find out how the attractions are repaired.
After performing the required marking at the indicated point, a painting tape is glued. You can tap the surface with a solid tool or nail. Drilling begins with a spear -shaped drill at low speeds. The drill must be kept at right angles to the tile.
The upper layer of enamel is the hardest and it is most difficult to pass, but in this case, patience and accuracy will be required. Do not press too much on the drill, t. To. Tiles can burst. The voids are also reduced to cracking at the place of drilling, so before drilling it is necessary to tap tiles.
After drilling the tile, you should replace the drill with a winning or other suitable for the wall. The hole is drilled to the depths of the dowel. If it is necessary to install large dowels, it is recommended to use drills of various sizes, while the work begins with the thinnest and gradually increase the hole.
