A few years ago, stretch ceilings were considered the subject of luxury and prosperity. But the construction market does not stand still and today this type of ceiling is available for most people of average abundance. Many do not know how they are mounted and believe that only professionals are capable of this. This is devoted to how the preparation and installation of a stretch ceiling occurs on its own.
Oddly enough, the installation of a hinged ceiling is not a difficult task, an unknown person, of course, seems different, but it is not at all. Naturally you need a little experience in repair work and the necessary invert. After you bought the ceiling canvas, you need to hold it in a warm place for several hours, while you can’t squeeze it with something. After prolonged storage on the ceiling canvas, “creases” are possible. This is not very scary over time, the ceiling will take the final look and the “creases” will disappear. Knowing the laws of physics, it is clear that the larger the area of the ceiling, the more it will strive for sagging.
Prior to the start of installation, it is necessary to carry out a number of preparatory work:
1. Remove the dimensions from the ceiling with great accuracy;
2. Fix the profile for fasteners;
3. Install the mount for lamps.
Installation of the ceiling itself consists of the following works:
– fixing and tension of the ceiling;
– installation of lamps in fastening.
Stages of preparation for the installation of a stretch ceiling:
The most basic and painstaking moment is the ceiling frozen. The entire subsequent installation of the ceiling depends on this moment.
On a sheet of paper, you need to at least schematically apply the size of the ceiling with an accuracy of up to 5mm. Measurements remove according to the elements of the fastener element. We must not forget about the locations of communications, pipes, windows, doors and others. This is necessary to place adhesions and seams on the canvas.
Along the perimeter of the entire ceiling, the profile is mounted on one to one. Pre -leveling in level. The length of this profile should be slightly less than the ceiling length by about 2 cm.
For a low ceiling, the profile is attached to the shock. But we must consider that there are still lamps, they must fit into the gap between the ceiling and profile.
During the corner docking, problems may appear. The profile is trimmed upside down by 45% previously retreating from the edge of 5 mm, this can be compared with the installation of skirting boards.
The profile is attached exclusively in the construction level. The scope of steps for walls made of concrete, drywall or brick is not more than 80 mm, for tiles and metal – not more than 120 mm.
It is necessary to determine in advance the location of the lamps, install the mount for them and bring electricity. An important point is to remember the places of fixtures of the lamps, it can be projected to the floor using a laser or a plumb line corresponding to lamps. This will be significantly needed after the ceiling is stretched and hidden under it.
This is where the preparation for installation is completed specifically about the installation itself you will learn from the second part of the article.
If you are interested in where you can buy a stretch ceiling in a prominent, look at Del-Campo. . There you can familiarize yourself with the prices and make an order.