The well on your site is undoubtedly part of the landscape and I want even this insignificant detail to look organically next to the house and deliver aesthetic pleasure.
Buying a house for a water source is much easier than making it yourself, but their cost in specialized stores, as well as installation services, by chance pushes us to the second option.
(Having taken up), first of all, make sure that the function of the well to provide pure water remains in perfect condition. This requires its protection against garbage, insects and rain drains.
Materials for the construction of a house for a well
– The design of the canopy for the well is simple. The most popular and economical material for its construction is wood.
– Therefore, first of all, stock up with wooden bars with the same cross -section of the required size.
– You will also need corners of metal and rod, logs, bushings, lining and accessories in the form of screws, loops.
– For wood processing, you will need protective impregnation. The final stage will be the fastening of the chain and bucket.
– As you can see, the list of materials, the house for the well will cost quite inexpensively, and even less time will go to the collection than to prepare.
Building a house for a well
The first stage
– The first stage of construction work is the study of all the parameters of the well.
The second stage
– (Hereinafter), according to the measurements made, we mount the basis. We mount the opposite sides in parallel and, as a rule, should be of the same size and diameter.
The third stage
– In the center of the side sides, the foundations set special vertical racks. Using them, you can connect the angles of the base with wooden bars.
– Here we need pre -acquired metal profiles that will give the design additional strength.
– The bars are attached to the frame of the house due to the grooves made in the racks. Bracyev’s slope should be exactly half of the right corner, which is easy to measure.
The fourth stage
– You can make a spindle from absolutely any log that suits its technical characteristics (strength, section thickness).
– The length of the wood should be three centimeters smaller than the distance between the structures. In the center of the log, we drill holes about two centimeters diameter, 5 centimeters thick.
The fifth stage
– We fix the metal profile to the ends, where the necessary holes should also be made. All this is performed and fixed using special self -tapping screws.
– We insert the reinforcement to the left of the spindle, it leaves the house by 2-4 cm, on the right, the reinforcement will be a handle, so it must be bent at an angle and put the tube with a slightly large diameter.
The sixth stage
– We approached the final stage of building a house for a well. Holes the size of a spindle height are made in the racks with a drill.
– They install bushings where spindle rods are held. So that the spindle does not creak, it is recommended to lubricate the bushings with solidol.
– This procedure will need to be carried out periodically as necessary. (Hereinafter) we attach the chain to the spindle, fasten the bucket and give the resulting design in motion.
– To make the use of the well even more comfortable, you can attach the board, it will be under the shelf for a bucket.
– The sizes of the board can be chosen arbitrarily, the main thing is that it withstands the load while using.
Design design
For a presentable appearance of your well, the house can be painted or covered with a special finish that is suitable for the general design of the site. Antiseptic processing will prevent the surface from environmental influences.
Having shown your imagination, you can improve this design option and create your own design solution, which will benefit the economy and delight the eye.